- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Disconnect the electrical connector from the backup lamp switch.
- Clean any dirt from around the backup lamp switch.
- Remove the lamp switch from the transmission.
- Check
that the transmission fluid level is even with the bottom of the fill backup lamp
switch hole.
- Add DEXRON®-III transmission fluid, if necessary.
Notice: Refer to Fastener Notice in the Preface section.
- Install the transmission backup lamp switch in the transmission.
Tighten
Tighten the switch to 28 N·m (21 lb ft).
- Connect the backup lamp switch electrical connector to the backup lamp
switch.
- Lower the vehicle.