Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the rear wheels. Refer to Tire and Wheel Removal and Installation.
- Disconnect the wheel speed sensor jumper harness electrical connector (1).
- Detach the electrical connector (1) from the right hand rail (2).
- Disconnect the left rear and right rear wheel speed sensor electrical connectors (1).
- Detach the wheel speed sensor wiring harness mounting clip (2) from the left rear and right rear knuckles (3).
- Detach the wheel speed sensor wiring harness mounting clip (1).
- Detach the wheel speed sensor wiring harness mounting clips (1) from the rear suspension subframe (2).
- Remove the wheel speed sensor jumper harness (2) from the vehicle.
Warning: Refer to Safety Glasses Warning in the Preface section.
Warning: Refer to Brake Dust Warning in the Preface section.
Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
Note: Note the routing of the wheel speed sensor jumper harness (3).
Installation Procedure
- Install the wheel speed sensor jumper harness (3) to the vehicle.
- Attach the wheel speed sensor wiring harness mounting clips (1) to the rear suspension subframe (2).
- Attach the wheel speed sensor wiring harness mounting clip (1).
- Connect the left rear and right rear wheel speed sensor electrical connectors (1).
- Attach the wheel speed sensor wiring harness mounting clip (2) to the left rear and right rear knuckles (3).
- Attach the electrical connector (1) to the right hand rail (2).
- Connect the wheel speed sensor jumper harness electrical connector (1).
- Install the rear wheels. Refer to Tire and Wheel Removal and Installation.
- Lower the vehicle.
- Use the scan tool in order to clear any DTCs.
- Perform the System Check - Vehicle. Refer to Diagnostic System Check - Vehicle.
Warning: Refer to Safety Glasses Warning in the Preface section.
Warning: Refer to Brake Dust Warning in the Preface section.
Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
Note: Make sure the routing of the wheel speed sensor jumper harness (3) is routed in its original location.
