Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the rear wheels. Refer to Tire and Wheel Removal and Installation.
- Disconnect the wheel speed sensor electrical connector (1).
- Remove the wheel speed sensor to knuckle retaining bolt (3).
- Remove the wheel speed sensor (2) from the knuckle (1).
Warning: Refer to Safety Glasses Warning in the Preface section.
Warning: Refer to Brake Dust Warning in the Preface section.
Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
Installation Procedure
- Install the wheel speed sensor (2) to the knuckle (1).
- Install the wheel speed sensor to knuckle retaining bolt (3) and tighten to 7 N·m (62 lb in).
- Connect the wheel speed sensor jumper harness electrical connector (1).
- Install the rear wheels. Refer to Tire and Wheel Removal and Installation.
- Lower the vehicle.
Warning: Refer to Safety Glasses Warning in the Preface section.
Warning: Refer to Brake Dust Warning in the Preface section.
Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
Caution: Refer to Fastener Caution in the Preface section.
