Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the battery ground cable. Refer to
Battery Negative Cable Disconnection and Connection.
- Remove the radiator air baffle and deflector. Refer to
Radiator Air Upper Baffle and Deflector Replacement
- Remove the front bumper fascia. Refer to
Front Bumper Fascia Replacement.
- Remove the headlamp. Refer to
Headlamp Replacement.
- Cut the headlamp assembly retaining brackets (1) along the broken line (A) as shown.
- Discard the remaining end of the headlamp assembly retaining brackets (1).
Installation Procedure
- Install the headlamp bracket (1) to the headlamp assembly (3).
Caution: Refer to Fastener Caution in the Preface section.
- Install the headlamp bracket to headlamp assembly retaining screws (2) and tighten to
1 N·m (9 lb in).
- Install the headlamp assembly (4) to the front end module (1).
Note: Replace the upper headlamp retaining bolts (2).
- Install the NEW headlamp assembly to front end module upper retaining washers (3) and bolts (2) and tighten to
4 N·m (35 lb in).
- Install the headlamp assembly to front end module lower retaining bolts (5) and tighten to
4 N·m (35 lb in).
Note: Make sure the headlamp assembly electrical connector locking tab (2) is correctly engaged. Failure to do so may cause an inoperative headlamp assembly.
- Connect the headlamp assembly electrical connector (1).
- Install the headlamp bracket (3) to the front end module (1).
- Install the headlamp bracket to front end module retaining bolts (2) and tighten to
4 N·m (35 lb in).
- Install the front bumper fascia. Refer to
Front Bumper Fascia Replacement.
- Install the radiator air baffle and deflector. Refer to
Radiator Air Upper Baffle and Deflector Replacement
- Connect the battery ground cable. Refer to
Battery Negative Cable Disconnection and Connection.
- Check all vehicle lights for correct operation.
- Adjust the headlamps. Refer to
Headlamp Aiming.