Special Tools

J 41712 Oil Pressure Sensor Socket

1. Turn the ignition OFF.
2. Remove the left hand engine cover. Refer to Engine Cover Replacement.



3. Disconnect the oil pressure sensor electrical connector (1).




Note: A small amount of oil will drain out of the oil filter housing when the oil pressure sensor is removed. Use a shop towel to absorb the oil.

4. Use the J 41712 in order to remove the oil pressure sensor (1).

Caution: Refer to Fastener Caution in the Preface section.




1. Use the J 41712 in order to install the oil pressure sensor (1) and tighten to 20 N·m (15 lb ft).



2. Connect the oil pressure sensor electrical connector (1).
3. Install the left hand engine cover. Refer to Engine Cover Replacement.