GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2009 🢒 G8 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Accelerator Pedal Position Sensor Replacement

Removal Procedure

    Caution: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.


    Object Number: 1950792 Size: SH
  1. Remove the left instrument panel (I/P) on the lower closeout insulator panel. Refer to Knee Bolster Replacement.
  2. Disconnect the electrical connector (1) to the accelerator pedal sensor module.
  3. Remove the accelerator pedal to steering column support bracket retaining bolts (2).
  4. Remove the accelerator pedal.

Installation Procedure

    Object Number: 1950792 Size: SH
  1. Install the accelerator pedal to the steering column support bracket.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the accelerator pedal to steering column support bracket retaining bolts (2) and tighten to 20 N·m (15 lb ft).
  3. Connect the accelerator pedal sensor module electrical connector (1).
  4. Inspect for correct carpet fit under the accelerator pedal.
  5. If re-programming is required, refer to Control Module References.
  6. Install the left I/P on the lower closeout insulator panel. Refer to Knee Bolster Replacement.