Crankshaft Balancer Removal L76
Special Tools
| • | J 41816 Crankshaft Balancer Remover |
| • | J 41816-2 Crankshaft End Protector |
| • | J 42386-A Flywheel Holding Tool |
For equivalent regional tools, refer to Special Tools.
- Install the J 42386-A holding tool and bolts.
- Remove the crankshaft balancer bolt (139).
- Use the J 41816 remover (1) and the J 41816-2 protector (2) in order to remove the crankshaft balancer.
- Remove the crankshaft balancer (138).
- Remove the J 42386-A holding tool and bolts.
Caution: Refer to Fastener Caution in the Preface section.
Note: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.
Use one M10 - 1.5 x 120 mm and one M10 - 1.5 x 45 mm bolt for proper tool operation. Tighten the J 42386-A holding tool bolts to 50 N·m (37 lb ft).
Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.
Crankshaft Balancer Removal 6.2L LS3
Special Tools
| • | J 41816-A Crankshaft Balancer Remover |
| • | J 41816-2 Crankshaft End Protector |
| • | J 42386-A Flywheel Holding Tool |
For equivalent regional tools, refer to Special Tools.
- Install the J 42386-A holding tool and bolts.
- Remove the crankshaft balancer bolt (139).
- Use the J 41816-A remover (1) and the J 41816-2 protector (2) in order to remove the crankshaft balancer.
- Remove the crankshaft balancer (1).
- Remove the crankshaft balancer washer (1) from the LS3 balancer as required.
Caution: Refer to Fastener Caution in the Preface section.
Note: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.
Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation. Tighten the J 42386-A holding tool bolts to 50 N·m (37 lb ft).
Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.
