GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 G6 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Mode Valve Actuator Replacement

Removal Procedure
  1. Remove the fuse labeled HVAC CTRL (BATT).
  2. Remove the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  3. Remove the knee bolster. Refer to Knee Bolster Replacement .

    4. Object Number: 1680189 Size: SH
  4. Remove the mode actuator retaining screws.
  5. Remove the mode actuator.
  6. Disconnect the mode actuator electrical connector.

Installation Procedure

    Object Number: 1680189 Size: SH
  1. Install the mode actuator.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the mode actuator retaining screws.

    3. Tighten
    Tighten the screws to 1.5 N·m (13 lb in).

  3. Connect the mode actuator electrical connector.
  4. Install the knee bolster. Refer to Knee Bolster Replacement .
  5. Install the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  6. Install the fuse labeled HVAC CTRL (BATT).