Tail Lamp Replacement. Pontiac G6 2007

For 1990-2009 cars only

Makes 🢒 Pontiac 🢒 2007 🢒 G6 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Tail Lamp Replacement

Tail Lamp Replacement Coupe

Callout	Component Name
Preliminary Procedure Pull back either the LR or RR compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
1	Tail Lamp Nut (Qty: 3) Notice: Refer to Fastener Notice in the Preface section. Tighten 2 N·m (18 lb in)
2	Tail Lamp Assembly Tip Pull lamp outboard and disconnect the electrical connector.

Callout

Component Name

Pull back either the LR or RR compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .

Tail Lamp Nut (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Tighten
2 N·m (18 lb in)

Tail Lamp Assembly

Tip
Pull lamp outboard and disconnect the electrical connector.

Callout	Component Name
Preliminary Procedure Remove either the LR or RR trunk liner. Refer to Rear Compartment Trim Panel Replacement .
1	Tail Lamp Assembly Nut (Qty: 2) Notice: Refer to Fastener Notice in the Preface section. Tip Tighten nuts in sequence as shown. Tighten 2 N·m (18 lb in)
2	Tail Lamp to Rear End Panel Locator Tip Pull lamp rearward to disconnect the lamp locator, then disconnect the electrical connector.
3	Tail Lamp Assembly Tip Connect electrical connector and locate upper outboard lamp locator to retainer in rear end panel, then push lamp inward in order to secure the locator to the rear end panel extension.

Callout	Component Name
Preliminary Procedure Remove either the LR or RR compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
1	Tail Lamp Nut (Qty: 1) Notice: Refer to Fastener Notice in the Preface section. Tighten 2 N·m (18 lb in)
2	Tail Lamp Retainer (Qty: 2)
3	Tail Lamp Assembly Tip Slide lamp housing over retainers to secure to body.