SMU - Revised Rear Shock Absorber Replacement

This bulletin is being issued to revise Step 2 of the Rear Shock Absorber Replacement installation procedure in the Rear Suspension sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.

Step 2 has been revised as follows:

2. Install the shock absorber to body nuts.

Tighten
Tighten the nuts to 25 N·m (18 lb ft).