For 1990-2009 cars only
Removal Procedure
- Position the front door window in the full down position.
- Apply masking tape to the outer applique and frame.
- Remove the trim panel. Refer to Front Side Door Trim Panel Replacement .
- Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
- Remove the inner belt sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
- Remove the outer belt sealing strip. Refer to Front Side Door Window Belt Outer Sealing Strip Replacement .
- Remove the window weatherstrip. Refer to Front Side Door Window Channel Replacement .
- Loosen the bolts (1) to the front and rear clevice clamps.
- Remove the window from the outside of the front door.
Installation Procedure
- Position the window between the inner and the outer door panels.
- Point the lower front corner of the window down and pass through the belt opening.
- Align the edges with the window weatherstrip channel.
- Turn the window to a horizontal position and align the window with the front and rear clevice clamps.
- Install the window weatherstrip. Refer to Front Side Door Window Channel Replacement .
- Install the outer belt sealing strip. Refer to Front Side Door Window Belt Outer Sealing Strip Replacement .
- Install the inner belt sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
- Inspect the window for proper operations.
- Remove the masking tape from the outer applique and frame.
- Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
- Install the inner trim panel. Refer to Front Side Door Trim Panel Replacement .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the front and rear clevice clamps bolts (1)
to 11 N·m (97 lb in).
Important: Do not allow the sealing lips on the outer belt sealing strip to roll over and point downwards. If this condition is present the window will not raise properly.
