GM Service Manual Online
For 1990-2009 cars only

Step

Action

Values

Yes

No

1

Did you perform the Daytime Running Lamp (DRL) System Check?

--

Go to Step 2

Go to Daytime Running Lights (DRL) System Check

2

  1. Turn the ignition switch to the ON position.
  2. Turn the light switch to the OFF position.
  3. Backprobe the DRL control module using a J 39200 from cavity 5 to ground.
  4. Measure the voltage.

Is the measured voltage greater than the specified range?

B+

Go to Step 3

Go to Step 4

3

  1. Backprobe the DRL control module connector using a J 39200 from cavity 7 to B+.
  2. Measure the voltage.

Is the measured voltage greater than the specified range?

B+

Go to Step 5

Go to Step 6

4

Repair the open in the BLK/WHT wire that is between the junction block and the DRL control module. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Daytime Running Lights (DRL) System Check

--

5

  1. Disengage the parking brake.
  2. Backprobe the DRL control module using a J 39200 from cavity 3 to B+.
  3. Measure the voltage.

Is the measured voltage greater than the specified range?

B+

Go to Step 7

Go to Step 8

6

Repair the open in the BLK wire the DRL control module and G 201. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Daytime Running Lights (DRL) System Check

--

7

  1. Start the engine.
  2. Backprobe the DRL control module connector using a J 39200 from cavity 4 to ground.
  3. Measure the voltage.

Is the measured voltage greater than or equal to the specified value?

B+

Go to Step 10

Go to Charging System Check in Engine Electrical

8

Inspect for a short to ground in the PPL or in the RED/YEL wire between the DRL control module and the parking-brake switch.

Is the connection OK?

--

Go to Step 9

Go to Step 12

9

Replace the parking brake. Refer to Park Brake Lever Assembly Replacement in Park Brake.

Is the repair complete?

--

Go to Daytime Running Lights (DRL) System Check

--

10

Inspect for an open in the RED/WHT wire that is between the DRL control module and S 104.

Is the connection OK?

--

Go to Step 11

Go to Step 12

11

Replace the DRL control module. Refer to Daytime Running Lights (DRL) Control Module Replacement .

Is the repair complete?

--

Go to Daytime Running Lights (DRL) System Check

--

12

Repair the wire. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Daytime Running Lights (DRL) System Check

--