Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Audible Warnings Schematics | |||
1 | Did you review the operation and perform the necessary inspections? | Go to Step 2 | |
2 | Turn the ignition on with the seat belt unbuckled. Does the fasten safety belt indicator illuminate? | Go to Step 3 | Go to Fasten Safety Belt Indicator/Chime Inoperative in Seat Belts |
3 | Turn the headlamps on. Are the headlamps on? | Go to Step 4 | Go to Low and High Beams Headlamps Inoperative in Lighting Systems |
4 |
Does the test lamp illuminate? | Go to Step 5 | Go to Step 8 |
5 |
Does the test lamp illuminate? | Go to Step 6 | Go to Step 7 |
6 | Test the park lamps supply voltage circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 17 | Go to Step 11 |
7 | Test the signal circuit of the driver door lock for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 17 | Go to Step 10 |
8 | Test the signal circuit of the ignition key alarm switch for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 17 | Go to Step 9 |
9 | Test the ground circuit of the ignition key alarm switch for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 17 | Go to Step 13 |
10 | Test the ground circuit of the driver door lock for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 17 | Go to Step 12 |
11 | Inspect for poor connections at the harness connector of the BCM connector C3. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 17 | Go to Step 16 |
12 | Inspect for poor connections at the harness connector of the driver door lock. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 17 | Go to Step 15 |
13 | Inspect for poor connections at the harness connector of the ignition key alarm switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 17 | Go to Step 14 |
14 | Replace the ignition key alarm switch. Refer to Steering Column Lock Cylinder Set - Disassemble - Off Vehicle and Steering Column Lock Cylinder Set - Assemble - Off Vehicle in Steering Wheel Column-Tilt. Did you complete the replacement? | Go to Step 17 | -- |
15 | Replace the driver door lock. Refer to Door Lock Replacement in Doors. Did you complete the replacement? | Go to Step 17 | -- |
16 | Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Did you complete the replacement? | Go to Step 17 | -- |
17 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 2 |
