To control spark knock or detonation, a knock sensor (KS) system is used. This system is designed to retard spark timing when excessive spark knock is detected in the engine. The KS system allows the engine to use maximum spark advance for optimal driveability and fuel economy under all operating conditions.

The powertrain control module (PCM) uses a knock sensors to detect abnormal vibration in the engine, such as detonation or spark knock. Mounted on the engine block, the knock sensors produces an AC voltage signal at all engine speeds and loads. The PCM then adjusts the spark timing based on the amplitude and frequency of the KS signal. The PCM uses the KS signal to calculate an average voltage. Next, the PCM assigns a voltage range above and below the average voltage value. The PCM checks the KS and related wiring by comparing the actual knock signal to the assigned voltage range. A normal KS signal should vary outside the assigned voltage range as shown in the NORMAL KS figure, If the PCM detects a KS signal within the assigned voltage range as shown in the ABNORMAL figure the applicable diagnostic trouble code (DTC) will be set.

1. Upper fail region
2. Knock sensor calculated average
3. Knock sensor signal
4. Lower fail region

1. Upper fail region
2. Knock sensor calculated average
3. Knock sensor signal
4. Lower fail region

A DTC may set for the following conditions or faults: