The Engine Scan Tool Data List contains all engine related parameters that are available on the scan tool. The list is arranged in alphabetical order. A given parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together.
Use the Engine Scan Tool Data List only after the following is determined:
| • | The Diagnostic System Check-Engine Controls is completed. |
| • | No diagnostic trouble codes (DTCs). |
| • | On-board diagnostics are functioning properly. |
Scan tool values from a properly running engine may be used for comparison with the engine you are diagnosing. The Engine Scan Tool Data List represents values that would be seen on a normally running engine.
Important: A scan tool that displays faulty data should not be used. The scan tool concern should be reported to the manufacturer. Use of a faulty scan tool can result in misdiagnosis and unnecessary parts replacement.
Only the parameters listed below are referenced in this service manual for use in diagnosis. If all values are within the typical range described below, refer to Symptoms - Engine Controls for diagnosis.
The column labeled Data List indicates where a parameter can be located on the scan tool. Refer to the scan tool operating manual for the exact locations of the data lists. The following is a description of each term listed:
All : The Parameter is in all data lists indicated below.Eng 1: Engine Data 1 List
Eng 2: Engine Data 2 List
EE: Enhanced EVAP Data
FF/FR: Freeze Frame/Failure Records
FT : Fuel Trim Data List
MF: Misfire Data List
Scan Tool Parameter | Data List | Parameter Range/Units | Typical Data Values |
|---|---|---|---|
Engine Idling/Radiator Hose Hot/Closed Throttle/Park or Neutral/Closed Loop/Accessories Off | |||
A/C Clutch Feedback Signal | Eng 2 | On/Off | Off |
A/C High Side Pressure | Eng 2 | 0-5 volts | Varies |
A/C High Side Pressure | Eng 2 | kPa/psi | Varies |
A/C Relay Command | Eng 1, 2, MF | On/Off | Off |
A/C Request Signal | Eng 2 | Yes/No | No |
AIR Pump Relay Command | Eng 1, 2, FT | On/Off | Off |
AIR Solenoid Command | Eng 1, FT | On/Off | Off |
Air Fuel Ratio | Eng 2, FF, FR | Ratio | 14.7:1 |
BARO | Eng 1, EE, FT, FF, FR | kPa/volts | 65-104 kPa/3.5-4.9 volts (varies w/altitude) |
CMP Sensor High to Low | Eng 2 | Counts | Varies |
CMP Sensor Low to High | Eng 2 | Counts | Varies |
Clutch Pedal Switch | Eng 1, 2 | Depressed/Released | Varies |
Cold Startup | Eng 2, EE | Yes/No | Varies |
Cruise Control Active | Eng 1 | Yes/No | No |
Cruise Inhibit Signal | Eng 1 | Yes/No | Yes |
Current Gear | Eng 2, FF, FR, FT | Transmission Gear Position | 1 |
Cycles of Misfire Data | MF | 0-100 Counts | Varies |
DTC Set This Ignition | Eng 1, 2, EE, FT | Yes/No | No |
Desired IAC Airflow | Eng 1 | 0-64 g/s | Varies |
Desired Idle Speed | Eng 1, 2, EE, FF, FR | RPM | PCM controlled |
ECT Sensor | All | -39° to +140°C (-38° to +284°F) | 85-113°C (185-235°F) |
Engine Load | All | 0-100% | 1-4% @ Idle 5-9% @ 2500 RPM |
Engine Run Time | Eng 1, 2, EE, FF, FR | Hrs, Min, Sec | Varies |
Engine Speed | All | 0-10,000 RPM | Varies |
EVAP Purge Solenoid Command | Eng 1, EE, FT, FR | 0-100% | 0-25% |
EVAP Vent Solenoid Command | Eng 1, EE, FT | Not Venting/Venting | Venting |
Fail Counter | FR | Counts | Varies |
Failures Since First Fail | FR | Counts | Varies |
FC Relay 1 Command | Eng 2 | On/Off | Depends on engine coolant temperature and A/C pressure |
FC Relay 2 and 3 Command | Eng 2 | On/Off | Depends on engine coolant temperature and A/C pressure |
Fuel Level Sensor | EE | 5-0 volts | 0.7-2.5 volts |
Fuel Tank Level Remaining | EE, FT | 0-16.6 gal/0-62.8 L | Varies |
Fuel Tank Level Remaining | EE, FT | 0-100% | Varies |
Fuel Tank Pressure Sensor | Eng 2, EE | -32.7 to +14.0 mm/Hg (-17.5 to +7.5 in/H2O) | Varies |
Fuel Tank Pressure Sensor | EE | 0-5.0 volts | Varies |
Fuel Tank Rated Capacity | EE | 16.6 gal./62.8 L | 16.6 gal/62.8 L |
Fuel Trim Cell | Eng 1, FT EE | 0-23 | 16, 17, 20 |
Fuel Trim Learn | Eng 1, EE, FT | Enabled/Disabled | Enabled (may toggle) |
Generator L Terminal Signal | Eng 2, | Voltage/No Voltage | Voltage |
HO2S Bank 1 Sensor 1 | Eng 1, EE, FT | Millivolts | 10-1,000 mV and varying |
HO2S Bank 1 Sensor 2 | Eng 1, EE, FT | Millivolts | 10-1,000 mV and varying |
HO2S Bank 2 Sensor 1 | Eng 1, FT, EE | Millivolts | 10-1,000 mV and varying |
HO2S Bank 2 Sensor 2 | Eng 1, FT | Millivolts | 10-1,000 mV and varying |
IAC Position | Eng 1, FT | Counts | Varies |
IAT | Eng 1, 2, EE, FT | -39 to +140°C (-38 to +284°F) | Varies |
Ignition 1Signal | Eng 1, 2, EE, FT | 0-25 volts | 11.5-14.5 volts |
Inj. PWM Average Bank 1 | Eng 2, EE, FT, FF, FR, MF | Milliseconds | 1-4 |
Inj. PWM Average Bank 2 | Eng 2, EE, FT, FF, FR, MF | Milliseconds | 1-4 |
Knock Retard | Eng 1, FT | 0.0-16° | 0° |
Long Term FT Average Bank 1 | FT | Percentage | Near 0% |
Long Term FT Average Bank 2 | FT | Percentage | Near 0% |
Long Term FT Bank 1 | Eng 1, 2, EE, FT, FF, FR, | Percentage | Near 0% |
Long Term FT Bank 2 | Eng 1, 2, EE, FT, FF, FR | Percentage | Near 0% |
Loop Status | Eng 1, 2, EE, FF, FR, FT | Open/Closed | Closed |
Low Oil Lamp | Eng 2 | On/Off | Off |
Low Oil Level | Eng 2 | Yes/No | No |
MAF Sensor | All | Grams per second (g/s) | 5-9 g/s @ idle (depends on altitude) 20-26 g/s @ 2,500 RPM (depends on altitude) |
MAF Frequency | Eng 2 | 0-31,999 Hz | Varies |
MAP | All | kPa/volts | 20-48 kPa/1.0-2.0 volts (varies w/ altitude) |
Mileage Since DTC Cleared | Eng 2 | km/Miles | Varies |
Mileage Since First Failure | FF, FR | km/Miles | Varies |
Mileage Since Last Failure | FR | km/Miles | Varies |
Mileage Since MIL Request | FF | km/Miles | Varies |
Misfire Current #1-#8 | MF | 0-200 Counts | 0 |
Misfire History #1-#8 | MF | 0-65,535 Counts | 0 |
Misfire Revolution Status | MF | Reject/Accept | Varies |
Not Run Counter | FR | Counts | Varies |
PCM Reset | Eng 1, 2, EE, FT | Yes/No | No |
PCM/VCM in VTD Fail Enable | Eng 2 | Enable/Disable | Disable |
PNP | Eng 2 | Park/Neutral R-D321 | Park/Neutral |
Pass Counter | FR | Counts | Varies |
Reverse Inhibit Solenoid | Eng 1 | Yes/No | No |
SHRT FT Average Bank 1 | FT | Percentage | Near 0% |
SHRT FT Average Bank 2 | FT | Percentage | Near 0% |
Short Term FT Bank 1 | Eng 1, 2, EE, FT, FF, FR | Percentage | Near 0% |
Short Term FT Bank 2 | Eng 1, 2, EE, FT, FF, FR | Percentage | Near 0% |
Skip Shift Lamp (M/T only) | Eng 1 | On/Off | Off |
Skip Shift Solenoid (M/T only) | Eng 1 | Enabled/Disabled | Disabled |
Spark | Eng 1, 2, FT, MF | Degrees | Varies |
Start Up ECT | Eng 2, EE, FF, FR, FT | C°/F° | Varies |
TCC Brake Switch | Eng 2, FF, FR | Applied/Released | Released |
TCC PWM Solenoid Command | Eng 1, 2, MF, FF, FR | Enabled/Disabled | Disabled |
TCC Enable Sol. | Eng 2, FF, FR | Enabled/Disabled | Disabled |
TFP SW | Eng 2, FT | 39-140°C (38-284°F) | Varies |
TP Sensor | All | 0-5.0 volts | 0.4-0.9 volts |
Traction Control Status | Eng 2, FF, FR | Active/Inactive | Inactive |
Transmission Range | FF, FR, FT | 0-4 | 1 |
Vehicle Speed Sensor | All | km/h mph | 0 |
VTD Auto Learn Timer | Eng 1, 2 | Minutes/Seconds | Varies |
VTD Fuel Disable | Eng 1, FF, FR | Active/Inactive | Inactive |
VTD Fuel Disable Until Ign. Off | Eng 1, 2 | Yes/No | No |
Warm-Ups w/o Emission Faults | Eng 2 | 0-255 Counts | Varies |
Warm-Ups w/o Non-Emission Faults | Eng 2 | 0-255 Counts | Varies |
