GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 13908  Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Important: Mark the alignment of the flywheel and the torque converter in order to retain a proper balance.

  3. Remove the torque converter cover. Refer to Torque Converter Cover Replacement .
  4. Remove the flywheel to torque converter bolts.

Installation Procedure


    Object Number: 13908  Size: SH

    Important: All flywheel to torque converter bolts should be hand started before tightening in order to ensure proper alignment, and in order to avoid cross-threading.

  1. Install the flywheel to torque converter bolts. Hand start the bolts.
  2. Tighten

        • Tighten the torque converter bolts for the 3.8L to 63 N·m (46 lb ft).
        • Tighten the torque converter bolts for the 5.7L to 60 N·m (44 lb ft).
  3. Install the torque converter cover. Refer to Torque Converter Cover Replacement or Coolant Heater Cord Replacement .
  4. Lower the vehicle.