GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Pontiac
🢒
2000
🢒
Firebird
🢒
Engine
🢒
Engine Controls - 3.8L
🢒 Fuel Pump Strainer Replacement
Removal Procedure
Important:
Always maintain cleanliness when servicing fuel system components.
Relieve fuel system pressure. Refer to
Fuel Pressure Relief
.
Raise the vehicle. Go to
Lifting and Jacking the Vehicle
in General Information.
Remove the fuel sender assembly. Refer to
Fuel Sender Assembly Replacement
.
Note the position of the strainer (5) for aid in installation.
Support the reservoir with one hand and grasp the strainer with the other hand.
Use a screwdriver to pry the strainer ferrule off the reservoir.
Discard the strainer.
Installation Procedure
Install the new strainer (5) to the reservoir.
Support the reservoir with one hand and grasp the strainer with the other hand twisting the strainer into position.
Install the fuel sender assembly. Refer to
Fuel Sender Assembly Replacement
.
Lower the vehicle.
Reconnect the negative battery cable. Refer to
Lifting and Jacking the Vehicle
in Engine Electrical.
Inspect for fuel leaks:
6.1.
Turn ON the ignition for 2 seconds.
6.2.
Turn OFF the ignition for 10 seconds.
6.3.
Turn ON the ignition.
6.4.
Check for fuel leaks.