Step | Action | Yes | No | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Automatic Level Control Schematics | |||||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information | ||||||||
2 | Verify the fault is present. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 | ||||||||
3 | Test the reset signal circuit of the accessory inflator switch for the following:
Refer to Circuit Testing , Testing for Short to Ground , Testing for a Short to Voltage , and Testing for Intermittent Conditions and Poor Connections in Wiring Systems. Did you find and correct the condition? | Go to Step 7 | Go to Step 4 | ||||||||
4 | Test the ground circuit of the accessory inflator switch for the following:
Refer to Circuit Testing , Testing for Short to Ground , Testing for a Short to Voltage , and Testing for Intermittent Conditions and Poor Connections in Wiring Systems. Did you find and correct the condition? | Go to Step 7 | Go to Step 5 | ||||||||
5 | Inspect for poor connections at the harness connector of the accessory inflator switch. Did you find and correct the condition? | Go to Step 7 | Go to Step 6 | ||||||||
6 | Replace the accessory inflator switch. Refer to Automatic Level Control Inflator Air Switch Replacement . Did you complete the replacement? | Go to Step 7 | -- | ||||||||
7 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | -- | ||||||||
