Important: There are 3 ways to reset the tire
pressure monitor (TPM) system. After resetting, the TPM system requires up
to 30 minutes of straight line driving in each of the 3 speed ranges
to complete the calibration process. For more information, refer to
Tire Pressure Monitor Description and Operation
. If the TPM system does
not reset using the Systems Monitor procedure, refer to
Low Tire Pressure Indicator Does Not Reset
. If the TPM system does not
reset using the driver information center (DIC) procedure, refer to
Driver Information Center (DIC) Switch Inoperative
in
Instrument Panel, Gages, and Console. If DTC C1245 remains current, refer to
Diagnostic System Check - Vehicle
in Vehicle
DTC Information.
Using the Systems Monitor
- Set all tire pressures to the recommended kPa/psi. Refer to
Tire Inflation Pressure Specifications
in Maintenance
and Lubrication, or to
Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label
in General Information.
- Turn ON the ignition, with the engine OFF.
- Press and hold the TIRE PRESS RESET button until the TIRE PRESS indicator
begins to flash.
- Release the TIRE PRESS RESET button and the TIRE PRESS indicator will
turn OFF.
- Use the scan tool in order to clear the TPM DTC.
Using the DIC, if equipped
- Set all tire pressures to the recommended kPa/psi. Refer to
Tire Inflation Pressure Specifications
in Maintenance
and Lubrication, or to
Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label
in General Information.
- Turn ON the ignition, with the engine OFF.
- Press the MODE button until TIRE PRESSURE is displayed.
- Press and hold the RESET button until TIRE PRESSURE RESET is displayed.
- Release the RESET button, TIRE PRESSURE NORMAL is displayed.
- Use the scan tool in order to clear the TPM DTC.
Using the Scan Tool
- Set all tire pressures to the recommended kPa/psi. Refer to
Tire Inflation Pressure Specifications
in Maintenance
and Lubrication, or to
Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label
in General Information.
- Install a scan tool.
- Turn ON the ignition, with the engine OFF.
- With the scan tool select Special Functions.
- Select Tire Pressure Reset.
- Press the Reset soft key.
- The TIRE PRESS indicator will turn OFF on the Systems Monitor,
or TIRE PRESSURE NORMAL is displayed on the DIC, if equipped.
- Use the scan tool in order to clear the TPM DTC.