DEFINITION: The tire press reset switch is inoperative.

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Turn ON the ignition, with the engine OFF.
2. With a scan tool, observe the Tire Reset Switch parameter in the IPC data list.
3. Press the TIRE PRESS RESET switch.

Does the scan tool display On when the switch is pressed?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Turn OFF the ignition.
2. Disconnect the reset switch.
3. Connect a 3-amp fused jumper wire between the harness connector of the reset switch signal circuit and a good ground.
4. Turn ON the ignition, with the engine OFF.
5. With a scan tool, observe the Tire Reset Switch parameter.

Does the scan tool display On?

Go to Step 6

Go to Step 4

Test the reset switch signal circuit for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 10

Go to Step 5

Test the ground circuit of the reset switch for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 10

Go to Step 7

Inspect for poor connections at the harness connector of the reset switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 10

Go to Step 8

Inspect for poor connections at the harness connector of the instrument cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 10

Go to Step 9

Replace the reset switch. Refer to Driver Information Display Switch Replacement in Instrument Panel, Gages, and Console.

Did you complete the replacement?

Go to Step 10

--

Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console.

Did you complete the replacement?

Go to Step 10

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2