For 1990-2009 cars only
Removal Procedure
- Remove the windshield defroster grille. Refer to Defroster Grille Replacement .
- Remove the instrument panel (I/P) trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
- Remove the I/P upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
- Remove the fasteners (1) from the head up display module (2) to the I/P.
- Lift the head up display module (2) from the I/P.
- Disconnect the electrical connector (3).
Installation Procedure
- Connect the electrical connector (3).
- Install the head up display module (2) into the I/P with the clip firmly snapped into the retaining bracket.
- Install the fasteners (1) retaining the head up display module to the I/P.
- Install the windshield defroster grille. Refer to Defroster Grille Replacement.
- Install the I/P upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement.
- Install the I/P trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement.
- Refer to Control Module References for programming and setup information.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners to 2 N·m (18 lb in).
