GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2005 🢒 Bonneville 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Radio Speaker Amplifier Replacement

Removal Procedure
  1. Remove the rear seat cushion. Refer to Rear Seat Cushion Replacement.
  2. Remove the rear seat back. Refer to Rear Seat Back Replacement.

    3. Object Number: 441826 Size: SH
  3. Disconnect the radio amplifier electrical connectors (2).
  4. Remove the fasteners securing the radio amplifier to the mounting bracket.
  5. Lift the radio amplifier to remove.

Installation Procedure

    Object Number: 441826 Size: SH
  1. Install the alignment tabs (1), on the radio amplifier, over the mounting bracket.
  2. Install the radio amplifier electrical connectors (2).

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the fasteners to retain the radio amplifier to the mounting bracket.

    4. Tighten
    Tighten the fasteners to 9 N·m (80 lb in).

  4. Install the rear seat back. Refer to Rear Seat Back Replacement.
  5. Install the rear seat cushion. Refer to Rear Seat Cushion Replacement.
  6. Refer to Control Module References for programming and setup information.