GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the right camshafts. Refer to Camshaft Replacement - Right Side .

  2. Object Number: 609694  Size: SH

    Important: If the followers are being reused, arrange them so that they may be put back in their original locations.

  3. Remove the camshaft followers.
  4. Clean and inspect the rocker arms. Refer to Valve Rocker Arms Cleaning and Inspection .

Installation Procedure


    Object Number: 235196  Size: SH
  1. Apply a liberal amount of lubricant GM P/N 12345001, or equivalent, to the roller pivot pocket (2) and valve slot areas (1) of the camshaft followers.

  2. Object Number: 591919  Size: SH

    Important: The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If the followers are being reused you must put them back in their original location.

  3. Place the camshaft followers in position on the valve tip (1) and the stationary hydraulic lash adjusters (SHLA) (1). The rounded head of the follower goes on the SHLA, while the flat end goes on the valve tip.
  4. Install the right camshafts. Refer to Camshaft Replacement - Right Side .