Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the air deflector. Refer to Front Air Deflector Replacement in Body Front End.
- Remove the oil filter adaptor. Refer to Oil Filter Adapter Replacement in Engine Mechanical-4.6L.
- Disconnect the crankshaft position sensor electrical connector.
- Remove the crankshaft sensor retaining bolt.
- Remove the crankshaft sensor.
Installation Procedure
- Lubricate the crankshaft sensor O-ring with clean engine oil.
- Install the crankshaft sensor and the retaining bolt.
- Connect the crankshaft position sensor electrical connector.
- Install the oil filter adaptor. Refer to Oil Filter Adapter Replacement in Engine Mechanical-4.6L.
- Install the air deflector. Refer to Front Air Deflector Replacement in Body Front End.
- Lower the vehicle.
- Operate the engine and inspect crankshaft sensor for engine oil leaks.
- Perform the Crankshaft Position System Variation Learn .
Important: Inspect the crankshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the retaining bolt between 10 N·m
(89 lb in).
