The numbers below refer to the step numbers on the diagnostic table.
Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
The symptom list in Symptoms will determine the correct diagnostic procedure to use.
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
At this point you have determined all DTCs applicable to the Body Rear End system. Any other codes displayed from the listed modules do not apply to Body Rear End and should be diagnosed in their applicable section.
Step | Action | Yes | No | ||||||
---|---|---|---|---|---|---|---|---|---|
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications | ||||||
Does the scan tool communicate with the DDM, RIM, and RFA? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |||||||
Select the following display DTC functions on the scan tool:
Does the scan tool display any DTCs? | Go to Step 4 | Go to Symptoms - Body Rear End | |||||||
Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 5 | |||||||
5 | Does the scan tool display DTC B1000, B1004, B1007, or B1009? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Step 6 | ||||||
Does the scan tool display DTC B1327, B1513, or B1514? | Go to Diagnostic System Check - Engine Electrical in Engine Electrical | Go to Symptoms - Body Rear End |