For 1990-2009 cars only
Removal Procedure
- Lower the rear of the headliner far enough to access the radio antenna module. Refer to Headlining Trim Panel Replacement in Interior Trim.
- Disconnect the electrical connectors from the radio antenna module.
- Remove the fastener securing the radio antenna module to the roof beam.
- Remove the radio antenna module.
Installation Procedure
- Install the radio antenna module to the roof beam, ensuring that the alignment tab is properly located.
- Install radio antenna module fastener.
- Connect the electrical connectors to the radio antenna module.
- Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fastener to 9 N·m (80 lb in).
