Tools Required

J 41352 Modular Column Holding Fixture

1. The turn signal switch assembly must be in the "UP" position.

Important: The column must be in the 12 o'clock position.

To align the steering shaft assembly to the 12 o'clock position. Turn the key to the off/lock position. Pull the key out and turn the steering shaft untill you hear a click.



2. Put the steering column in J 41352 .
3. Pop the wire harness assembly out of the wire harness strap (1).
4. Check steering column for accident damage. Refer to Steering Column Accident Damage Inspection - Off Vehicle .



5. Use a screwdriver to pry the electrical BTSI actuator from the steering column jacket assembly.
6. Remove the electrical BTSI actuator (3) from the steering column lower support (2) and the shift tube (1).