SERVICE GUILD: SMU SEC. 8C SAFETY BELT RELEASE TIMER

VEHICLES AFFECTED: 1990 C AND H

Refer to safety belt retractor release solenoid timer removal and installation at approximately page 8C-9, of your service manual.

The following illustration shows the removal and installation procedure for the safety belt retractor release solenoid timer. The timer is located on the right side of the instrument panel, lower left of relay centre.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.