For 1990-2009 cars only
Removal Procedure
- For the Aztek, remove the rear roof garnish molding. Refer to Rear Upper Garnish Molding Replacement .
- Remove the rear seat belt guide loop from the rear upper quarter trim panel. Refer to Rear Seat Belt Retractor Replacement in Seat Belts.
- Remove the bolt from the rear upper quarter trim panel.
- Remove the trim panel from the rear quarter inner panel, by pulling the panel to release the push-in retainers.
- Remove the trim panel from the vehicle.
Installation Procedure
- Align the push-in retainers on the rear quarter upper trim panel to the rear quarter inner panel.
- Install the push-in retainers, applying pressure to secure at all of the retainers locations.
- Install the bolt to the rear upper quarter trim panel.
- Install the rear seat belt guide loop to the rear upper quarter trim panel. Refer to Rear Seat Belt Retractor Replacement in Seat Belts.
- For the Aztek, install the rear roof garnish molding. Refer to Rear Upper Garnish Molding Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the trim bolt to 6 N·m (53 lb in).
