Liftgate Weatherstrip Replacement Aztek

1. Open the liftgate.
2. Remove the endgate sill plate. Refer to Rear Floor Rear Trim Plate Replacement in Interior Trim.
3. Pull the liftgate weatherstrip from the liftgate opening pinch-weld flange.
4. Clean all the adhesive from the liftgate opening pinch-weld flange using GM P/N 8984 adhesive remover or equivalent.

Important: A mastic/sealer/glue is inside of new liftgate weatherstrips. If a new weatherstrip in being installed, weatherstrip adhesive should not be used.

If the liftgate weatherstrip is reused, weatherstrip adhesive should be used.



1. Install the liftgate weatherstrip, starting at the top center of the liftgate opening position the liftgate weatherstrip to the pinch-weld flange and working down the right and left sides towards the bottom center, being careful not to stretch the liftgate weatherstrip while installing it.
2. Install the butt joint seam at the center of the bottom pinch-weld flange.
3. Use a rubber mallet to ensure full engagement of the liftgate weatherstrip to the pinch-weld flange.
4. Spooning of the liftgate weatherstrip may be required to complete the installation of the liftgate weatherstrip.
5. Install the endgate sill plate. Refer to Rear Floor Rear Trim Plate Replacement in Interior Trim.
6. Close the liftgate.