Rear Side Door Warning Reflector Replacement Aztek

1. Open the rear door.
2. Apply protective coating/tape at the point of insertion of the flat bladed tool.
3. Remove the warning reflector from the rear door trim panel using a small flat bladed tool, pressing on the tabs from the top of the warning reflector.



4. Remove the warning reflector from the rear door trim panel.

1. Position the warning reflector to the rear door trim panel.



2. Install the warning reflector into the rear door trim panel pressing in until fully seated.
3. Remove the protective coating/tape from the point of insertion.
4. Close the rear door.