Rear Bumper Fascia Replacement Aztek

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Open the endgate.
2. Using J 38778 , remove te rear bumper fascia push-in retainers at the inboard side of the rear quarter panel.



3. Using J 38778 , remove the push-in retainers from the rear bumper fascia at the rear impact bar.



4. Using J 38778 , remove the push-in retainers from the rear bumper fascia upper tabs.
5. Remove the rear bumper fascia from the vehicle.



6. Remove the grommets from the rear pillar using a small flat-bladed tool, if required.

1. Install the grommets to the rear pillar, if removed.
2. Position the rear bumper fascia to the vehicle.



3. Install the rear bumper fascia tabs to the rear quarter moldings.
4. Starting at the center hole, install the push-in retainers to the lower rear bumper fascia.



5. Install the push-in retainers to the rear bumper fascia upper tabs.



6. Install the rear bumper fascia push-in retainers to the inboard side of the rear quarter panel.
7. Close the endgate.