GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2001 🢒 Aztek - FWD 🢒 Body and Accessories 🢒 Bumpers 🢒 Front Bumper Fascia Upper Support Replacement

Removal Procedure

    Object Number: 621383 Size: SH
  1. Remove the fascia. Refer to Front Bumper Fascia Replacement .
  2. Remove the hood latch and cable. Refer to Hood Primary Latch Release Cable Replacement .
  3. Disconnect the headlamp wiring harness from the fascia upper support.
  4. Remove the bolts from the fascia upper support.

    5. Object Number: 621384 Size: SH
  5. Remove the fascia upper support from the upper radiator support.

Installation Procedure

    Object Number: 621384 Size: SH
  1. Position the fascia upper support to the upper radiator support.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 621383 Size: SH
  2. Install the bolts to the fascia upper support.

    3. Tighten
    Tighten the bolts to 5 N·m (44 lb in).

  3. Install the bolts to the fascia lower support.

    4. Tighten
    Tighten the fascia lower support bolts to 10 N·m (89 lb in).

  4. Connect the headlamp wiring harness to the fascia upper support.
  5. Install the hood latch and cable. Refer to Hood Primary Latch Release Cable Replacement .
  6. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement .