Cruise control is a speed control system that maintains a desired vehicle speed under normal driving conditions. However, steep grades may cause variations in the selected speeds. The electronic cruise control system has the capability to CRUISE, COAST, RESUME SPEED, ACCELERATE, and TAP-UP or TAP-DOWN.

The main parts of the cruise control system are:

The cruise control system uses the cruise control module assembly to maintain the desired vehicle cruise speed and operation. The cruise control module assembly has a controller and an electric stepper motor to vary the throttle in each different cruise control mode. Two components in the module assembly help to do this. The electronic controller and the electric stepper motor. The controller monitors vehicle speed and operates the stepper motor. The stepper motor operates in response to the controller, to maintain the desired cruise speed. The electric stepper motor moves a strap that is attached to the cruise control cable which moves the throttle linkage. The cruise control module assembly contains a low speed limit which will prevent system engagement below a minimum speed of 40 km/h (25 mph). The module assembly is not serviceable.

The operation of the controller is controlled by the function control switches located on the multifunction turn signal lever. The cruise control functional control switches include the ON/OFF, SET/COAST, R/A . The switch assembly provides driver control of the cruise control system.

The cruise control release switch and stop lamp switch are used to disengage the cruise control. A release switch assembly and a stop lamp switch assembly are mounted on the brake pedal bracket . To disengage the system the driver presses the brake pedal. The speed of the vehicle at brake actuation will be stored in the memory of the cruise module.

With cruise control, you can maintain a speed of about 40 km/h (25 mph) or more without keeping your foot on the accelerator. When the driver turns off the on/off switch or ignition switch, the cruise control turns off. The vehicle speed stored in the memory of the cruise module will be lost.

Ignition 1 voltage is supplied from the cruise control fuse, to the cruise control module. The cruise control module is grounded to the chassis. When the cruise control ON/OFF switch is on, ignition 1 voltage is applied to the cruise on switch signal circuit of the cruise control module. If the driver has not pressed the brake pedal, ignition positive voltage is supplied through the cruise control release switch, to the cruise control release signal circuit of the cruise control module. When the driver presses the brake pedal, battery positive voltage is supplied from the stop lamp fuse, through the closed stop lamp switch to the stop lamp switch signal circuit of the cruise control module. When the SET/COAST button is pressed , ignition positive voltage is applied to the set/coast switch signal circuit of the cruise control module. When pressing the R/A, ignition positive voltage is applied to the resume/ accelerate switch signal circuit of the cruise control module.

The cruise control module receives a vehicle speed signal input from the Powertrain Control Module (PCM). In operation, the voltage varies between 0 V and 5 V.

The cruise control module, cruise engaged signal circuit, sends a signal to the PCM when cruise is engaged. The cruise control module, cruise cancel signal circuit, is a circuit used by the PCM to inhibit cruise control when conditions inconsistent with cruise operation are present.

The PCM will inhibit cruise control:

If the PCM determines that any of the cruise control inhibit conditions are present, the PCM will disengage the cruise control . The PCM accomplishes this by opening the cruise control inhibit signal circuit. If the cruise engaged signal, sent by the cruise control module to the PCM, indicates that the cruise control is still engaged after the PCM has requested that the cruise control disengage, the PCM sets a DTC.