Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: Wiper/Washer Schematics | ||||
1 | Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections? | -- | Go to Step 2 | |
2 |
Do the windshield wipers operate properly in all modes? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Do the windshield wipers operate properly in HI mode? | -- | Go to Step 4 | Go to Step 7 |
4 |
Does the voltage measure near the specified value? | B+ | Go to Step 5 | Go to Step 8 |
5 |
Does the voltage measure near the specified value in each DELAY position? | B+ | Go to Step 6 | Go to Step 13 |
6 | Measure the voltage from the windshield wiper switch on signal circuit to a good ground. Does the voltage measure near the specified value? | B+ | Go to Step 11 | Go to Step 9 |
7 |
Does the voltage measure near the specified value? | B+ | Go to Step 12 | Go to Step 10 |
8 | Test the windshield wiper switch low/pulse signal circuit for a short to ground or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 17 | Go to Step 13 |
9 | Test the windshield wiper switch on signal circuit for short to ground or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 17 | Go to Step 13 |
10 | Test the windshield wiper motor high speed circuit for short to ground or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 17 | Go to Step 13 |
11 | Inspect for a poor connection at the windshield wiper motor connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 17 | Go to Step 14 |
12 | Inspect for a poor connection at the windshield wiper motor connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 17 | Go to Step 15 |
13 | Inspect for a poor connection at the windshield wiper/washer switch connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 17 | Go to Step 16 |
14 | Replace the windshield wiper motor cover. Refer to Wiper Motor Cover Replacement . Did you complete the replacement? | -- | Go to Step 17 | -- |
15 | Replace the windshield wiper motor. Refer to Windshield Wiper System Module Replacement . Did you complete the replacement? | -- | Go to Step 17 | -- |
16 | Replace the windshield wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt. Did you complete the replacement? | -- | Go to Step 17 | -- |
17 | Operate the windshield wiper/washer system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 3 |
