GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2001 🢒 Aztek - FWD 🢒 Body and Accessories 🢒 Wipers/Washer Systems 🢒 Windshield Reveal Molding Replacement

Removal Procedure

Important: 

   • Be sure to pre-fit the windshield reveal molding to the windshield then as an assembly on the body prior to actual installation.
   • When replacing the windshield, the original windshield reveal molding cannot be reused and must be replaced with a new molding.
   • The new windshield reveal moldings are primed and will adhere to the urethane adhesive.
   • A heat lamp may be used to make the windshield reveal molding more pliable.
   • The windshield reveal molding cannot be replaced without removing the windshield.


    Object Number: 506223 Size: SH
  1. Remove the windshield using a flat-bladed tool, and carefully pry the end of the windshield reveal molding out about 75 mm (3 in).
  2. Grasp the windshield reveal molding by hand and slowly pull the windshield reveal molding away from the body.
  3. Remove the windshield. Refer to Windshield Replacement .

Installation Procedure

    Object Number: 506223 Size: SH
  1. Start from center and hand press the windshield reveal molding into place.

    2. Tape can be applied to keep windshield reveal molding flush with windshield.

  2. Pre-fit the windshield reveal molding to the windshield.

    3. Then as an assembly pre-fit it to the vehicle prior to actual installation.

  3. Install the windshield. Refer to Windshield Replacement .