GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2001 🢒 Aztek - FWD 🢒 Body and Accessories 🢒 Lighting Systems 🢒 Parking and Turn Signal Lamp Replacement

Removal Procedure

    Object Number: 621212 Size: SH
  1. Open the hood.
  2. Remove the screws from the front parking/sidemarker lamp.

    3. Object Number: 623906 Size: SH
  3. Disconnect the front parking/sidemarker lamp wiring harness from the pinch-weld flange.

    4. Object Number: 621230 Size: SH
  4. Remove the front parking/sidemarker lamp from the front fender.

    5. Object Number: 623914 Size: SH
  5. Remove the front parking/sidemarker lamp socket, depressing the locking tab and turning counterclockwise.

    6. Object Number: 623902 Size: SH
  6. Remove the bulb from the front parking/sidemarker lamp socket, if replacing the bulb.

Installation Procedure

    Object Number: 623902 Size: SH
  1. Install the bulb to the front parking/sidemarker lamp socket, if replacing the bulb.

    2. Object Number: 623914 Size: SH
  2. Install the front parking/sidemarker lamp socket, turning the socket clockwise until the locking tab is fully seated.

    3. Object Number: 623911 Size: SH
  3. Connect the front parking/sidemarker lamp wiring harness to the pinch-weld flange.

    4. Object Number: 623920 Size: SH
  4. Align the ball stud of the front parking/sidemarker lamp to the grommet in the fender reinforcement.

    5. Object Number: 623923 Size: SH
  5. Position the alignment pins of the front parking/sidemarker lamp to the to the holes in the fender reinforcement.

    6. Object Number: 621230 Size: SH
  6. Install the front parking/sidemarker lamp to the front fender, pressing into place until fully seated.

    7. Object Number: 621212 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the screws to the front parking/sidemarker lamp.

    8. Tighten
    Tighten the front parking/sidemarker lamp screws to 2 N·m (18 lb in).

  8. Close the hood.