Inspect for loose and/or
missing propeller shaft-to-flange bolts (2) and (4). Tighten and/or replace
as necessary. Refer to
Propeller Shaft Replacement
.
The propeller shaft (3) and the constant velocity joints are not serviceable.
The CV joints and seals should be inspected periodically, whenever the vehicle
is serviced.
The CV joint seals should be inspected for the following:
| • | Contamination of the lubricating grease by carefully pinching
the seal and feeling for grit |
| • | Loose or missing clamps |
| • | Leakage of lubricating grease |
The CV joints should be inspected for the following conditions:
| • | Binding or impeded motion during axial movement of the front and
rear CV joints |
| • | Binding or impeded motion during lateral movement of the rear
CV joint |
| • | Loose or missing crimped-on end caps |
| • | Leakage of lubricating grease from the end caps |
The propeller shaft must be replaced if any of the above conditions
exist. This will ensure that the propeller shaft continues to operate as intended,
and does not cause damage to the other driveline components.
