GM Service Manual Online
For 1990-2009 cars only

Rear Side Door Trim Panel Replacement Aztek

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

Removal Procedure


    Object Number: 621721  Size: SH
  1. Remove the power window switch. Refer to Rear Side Door Window Switch Replacement .
  2. Remove the power door lock switch (if equipped). Refer to Door Lock Switch Replacement .
  3. Remove the screws from the rear door trim panel.

  4. Object Number: 621719  Size: SH
  5. Remove the rear door trim panel using J 38778 .
  6. Disconnect and reroute any electrical harness or connectors.
  7. Remove the rear door trim panel from the vehicle.

Installation Procedure

    Important: Before installing the rear door trim panel to the rear door inner panel, the old trim panel retainers MUST be discarded and replaced with NEW trim panel retainers.


    Object Number: 621719  Size: SH
  1. Install the new trim panel retainers to the rear door trim panel.
  2. Connect and route the electrical connectors through the openings in the rear door trim panel.
  3. Align the rear door trim panel to the rear door inner panel, guiding the rear door handle through the trim panel.
  4. Install the upper edge of the rear door trim panel to the top edge of the inner door panel, pressing down firmly until the rear door trim panel is fully seated.
  5. Install the rear door trim panel pressing firmly until the retainer clips are fully seated around the perimiter of the trim panel.
  6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 621721  Size: SH
  7. Install the screws to the rear door trim panel.
  8. Tighten
    Tighten the rear door trim panel screws to 6 N·m (53 lb in).

  9. Install the power door lock switch (if equipped). Refer to Door Lock Switch Replacement .
  10. Install the power window switch. Refer to Rear Side Door Window Switch Replacement .