Tools Required

J 41718 Sunroof Timing Pins

Important: This sunroof system is timed from the factory in order to allow the actuator to shut off automatically when the sunroof window reaches a certain position. Use extreme care when removing the sunroof actuator from the sunroof module. Improper removal may cause the timing to be thrown off. Anytime the sunroof actuator requires removal from the sunroof module, ensure that the sunroof window is in the fully closed position and the sunroof timing pins are installed.

1. Position the sunroof glass panel to the fully closed position.
2. Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.



3. Remove the right and left front screw from the sunroof glass panel. Refer to Sunroof Glass Panel Replacement .

Important: Before removing the sunroof actuator, ensure that J 41718 are tight and holding the cable.

4. Install J 41718 into the front sunroof glass panel screw hole in order to retain the cable adjustment.



5. Disconnect the electrical connector from the sunroof module actuator.



6. Remove the bolts from the sunroof actuator.



7. Remove the sunroof actuator from the sunroof module.

1. Install the sunroof actuator to the sunroof module.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the sunroof actuator bolts.

Tighten
Tighten the sunroof actuator bolts to 4 N·m (35 lb in).

3. Connect the electrical connector to the sunroof actuator.



4. Remove the sunroof timing pins.
5. Install the front screws to the sunroof glass panel. Refer to Sunroof Glass Panel Replacement .
6. Check the sunroof for proper operation.
7. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.