Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Body Control Module (BCM) System Check performed?
| --
| Go to
Step 2
| Go to
Diagnostic System Check - Body Control System
|
2
|
- Remove the key from the ignition key lock cylinder.
- Close all vehicle doors.
- While observing the door locks, press LOCK, then press UNLOCK
on the driver's door lock switch.
- While observing the door locks, press LOCK, then press UNLOCK
on the passenger door lock switch.
Do all of the doors lock and unlock when using either door lock switch?
| --
| Go to
Step
3
| Go to
Automatic Door Locks System Check
|
3
|
- Disconnect the RCDLR electrical connector.
- Disconnect the BCM connector C2.
- Using a J 39200
digital multimeter (DMM), measure the resistance between the BCM harness
connector C2 terminal C8 and the RCDLR harness connector terminal E.
Is the resistance within the specified value?
| Less than 2 ohms
| Go to
Step 4
| Go to
Step 5
|
4
|
- Replace the RCDLR. Refer to
Receiver Replacement
.
- Reconnect the BCM.
- Reporgram all transmitters. Refer to
Transmitter Programming
.
- Remove the key from the ignition key cylinder lock.
- Close all of the vehicle doors.
- While observing the door locks, press once on the lock button
on the keyless entry transmitter.
- While observing the door locks, press twice on the unlock button
on the keyless entry transmitter.
- While observing the exterior lights and while listening to the
horn, press the alarm button (if equipped) on the keyless entry transmitter.
Does the keyless entry system operate the door locks and the optional
alarm?
| --
| System OK
| Go to
Step 6
|
5
| Repair a poor connection
or an open in CKT 1455.
Is the symptom still present?
| --
| Go to
Step 7
| System OK
|
6
| Replace the BCM.
Is the symptom still present?
| --
| Go to
Step 7
| System OK
|
7
|
- Turn the ignition switch to the LOCK position.
- Reinstall all connectors/components.
- Turn the ignition switch to the RUN position for 6 seconds.
- Turn the ignition switch to the LOCK position.
- Remove the BCM PRGRM fuse.
- Turn the ignition switch to the ACC position. (The BCM sounds
the chime a number of times equivalent to the BCM type installed on the vehicle).
- Within 1 second, turn the ignition switch from the ACC
position, to the LOCK position, then back to the ACC position. (The BCM sounds
any DTCs stored).
Are any BCM DTC present?
| --
| Go to
Diagnostic System Check - Body Control System
| --
|
