Removal Procedure
- Remove the left side rear quarter trim. Refer to
Rear Quarter Lower Trim Panel Replacement
in Interior
Trim.
- Remove the upper mounting bolts and nut to the heater A/C module
and reposition rearward enough for access.
- Disconnect electrical
connector at the temperature valve electric actuator.
- Remove the screws securing
the temperature valve electric actuator.
- Remove the temperature valve electric actuator.
Installation Procedure
- Install the temperature
valve electric actuator.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the temperature
valve electric actuator mounting screws.
Tighten
Tighten the screws to 1.6 N·m (14 lb in).
- Install the electrical
connector to the temperature valve electric actuator.
- Install the upper mounting bolts to the heater A/C module.
Tighten
Tighten the bolts and nut to 10 N·m (89 lb in).
- Install the left side rear quarter trim. Refer to
Rear Quarter Lower Trim Panel Replacement
in Interior
Trim.