- Remove the sliding door upper garnish molding. Refer to Rear Side Door Garnish Molding Replacement .
- Loosen 1 bolt on the sliding door upper roller bracket.
- Loosen 1 bolt on the sliding door lower bracket.
- Adjust the front edge of the sliding door in or out, as needed.
- Tighten the bolt that you loosened on the sliding door lower roller bracket.
- Tighten the bolt the that you loosened on the sliding door upper roller bracket.
- Install the sliding door upper garnish molding. Refer to Rear Side Door Garnish Molding Replacement .
Important: Loosen only 1 bolt at a time on the following brackets:
• The sliding door lower roller bracket • The sliding door upper roller bracket
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the sliding door lower roller bracket bolt to 25 N·m
(18 lb ft).
Tighten
Tighten the sliding door upper roller bracket bolt to 25 N·m
(18 lb ft).
