Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the entire power windows system check performed?
| --
|
Go to Step 2
| Go to
Power Windows System Check
|
2
|
- Place the ignition switch into the RUN position.
- Disconnect the LF window regulator motor connector.
- Using a test light, backprobe the LF window regulator motor connector
from terminal A to terminal B.
- Press the LF window switch UP and then DOWN.
Does the test light illuminate after both actions?
| --
|
Go to Step 3
|
Go to Step
4
|
3
| Replace the LF window regulator motor. Refer to
Front Side Door Window Regulator Replacement
.
Is the repair complete?
| --
|
Go to Step
7
| --
|
4
|
- Turn the ignition switch to the OFF position.
- Disconnect the LF window switch.
- Using a DMM, check CKT 164 and 165 for continuity, and a short
to ground.
Are any of these conditions present?
| --
|
Go to Step 5
|
Go to Step
6
|
5
| Repair the open, or short to ground in CKT 164 or 165.
Is the repair complete?
| --
|
Go to Step
7
| --
|
6
| Replace the LF window switch. Refer to
Door Trim Plate Replacement
.
Is the repair complete?
| --
|
Go to Step
7
| --
|
7
|
- Turn the ignition switch to the OFF position.
- Reconnect all connectors/components removed.
Have all the repairs been made?
| --
| Go to
Power Windows System Check
| --
|
