Was the entire power windows system check performed?

--

Go to Step 2

Go to Power Windows System Check

1. Turn the ignition switch to the RUN position.
2. Using a test light, backprobe the LF window switch connector from terminal H to ground.

Does the test light illuminate?

--

Go to Step 3

Go to Step 4

Using a test light, backprobe the LF window switch connector between terminal H and terminal G.

Does the test light illuminate?

--

Go to Step 5

Go to Step 6

1. Test for a poor connection at C200 terminal A8.
2. If OK, repair the open in CKT 141, between PWR WDO circuit breaker and S307.

Is the repair complete?

--

Go to Step 7

--

Replace the LF window switch. Refer to Door Trim Plate Replacement .

Is the repair complete?

--

Go to Step 7

--

Repair the open in CKT 750, between LF window switch assembly connector terminal G and S504.

Is the repair complete?

--

Go to Step 7

--

1. Turn the ignition switch to the OFF position.
2. Reconnect all connectors/components removed.

Have all the repairs been made?

--

Go to Power Windows System Check

--