Air Cleaner Element Replacement Housing Replacement

1. Remove the bolt from the coolant tank.
2. Remove the coolant tank and set aside.
3. Remove the 3 bolts from the support brace and remove the brace.
4. Disconnect the MAF sensor electrical connector.
5. Loosen the 2 clamps on the duct/MAF sensor assembly.
6. Remove the air inlet duct/MAF sensor assembly (1).



7. Unsnap the 2  latches and remove the air cleaner housing cover (2).
8. Remove the air filter element (3).
9. Unsnap the latch on the upper cover and remove the cover.



10. Carefully remove the PCM leaving the 2 harnesses connected and set aside.



11. Remove the 2 bolts (2) from the air cleaner assembly and remove the housing.

1. Position the air cleaner housing on the stud (3).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the 2 bolts (1) through the housing.



3. Carefully reinstall the PCM into the housing.
4. Reinstall the upper cover and snap it in place.



5. Reinstall the air cleaner element (3) and air cleaner cover (2) and snap them in place.
6. Reinstall the air inlet duct/Map sensor assembly (1)and tighten the 2 clamps.
7. Connect the MAF sensor electrical connector.
8. Position the support brace and install the 3 bolts.
9. Reinstall the coolant tank and reinstall the retaining bolt.

Air Cleaner Element Replacement Filter Replacement

1. Disconnect the MAF sensor electrical connector.
2. Loosen the air intake duct/MAF sensor hose clamps.
3. Remove the air intake duct/MAF sensor assembly (1).



4. Unsnap the 2 housing cover retaining clamps.
5. Remove the air cleaner cover (2) and carefully remove the air filter element (3).
6. Inspect the housing cover, seal assembly, and air ducting for damage. If a problem is found, replace as necessary.

1. Carefully install the air filter element (3) into the air cleaner assembly.
2. Reinstall the housing cover (2)and snap the retaining clamps in place.
3. Reinstall the air intake duct/MAF sensor assembly (1).
4. Tighten the air intake duct/MAF sensor hose clamps.
5. Connect the MAF sensor electrical connector.