For 1990-2009 cars only
Removal Procedure
- Raise the front floor console armrest.
- Remove the screws from the front floor console trim plate.
- Open the front floor console cupholder.
- Pull up on the front floor console trim plate starting at the rear and working forward to release the retainer clips.
- Remove the traction control switch from the front floor console trim plate. Refer to Electronic Traction Control Switch Replacement .
- Lift the front floor console trim plate up and over the transaxle shift lever.
- Remove the front floor console trim plate from the front floor console.
Installation Procedure
- Align the front floor console trim plate to the front floor console.
- Install the traction control switch to the front floor console trim plate. Refer to Electronic Traction Control Switch Replacement .
- Install the front floor console trim plate to the front floor console pressing into place until fully seated.
- Install the screws to front floor console trim plate.
- Close the front floor console cupholder.
- Lower the front floor console armrest.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the front floor console trim plate screws to 2 N·m
(18 lb in).
