Removal Procedure
- Disconnect the electrical connector (3) from the mass airflow (MAF) sensor .
- Loosen the 2 band clamps located on either side of the MAF sensor (4).
- Disconnect the intake air duct of the throttle body from the MAF sensor.
- Remove the MAF sensor from the air cleaner assembly.
Notice: Do not damage the MAF sensor screen. A damaged screen could restrict airflow and lead to a driveability concern.
Installation Procedure
- Insert the MAF sensor into the air cleaner assembly duct.
- Connect the intake air duct to the MAF sensor.
- Connect the electrical connector to the MAF sensor .
Notice: Do not damage the MAF sensor screen. A damaged screen could restrict airflow and lead to a driveability concern.
Important: The MAF sensor must be mounted with the air flow direction arrow located on top of the MAF sensor pointing with air flow toward the throttle body. Ensure that the MAF sensor locating tabs and the locating slots of the intake air ducts line up before connecting the MAF sensor and the intake air ducts.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 2 band clamps to 3.5 N·m (31 lb in).
