Removal Procedure
Tools Required
J 25070 Heat Gun
- Apply heat to the hood
emblem, using J 25070
152 mm
(6 inches) from the surface.
- Apply the heat using a circular motion for about 30 seconds.
- Gently remove the emblem from the panel surface, being careful
not to damage paint.
- Remove all adhesive from the hood using a 3M ™scotch brite
molding adhesive remover disk (3M™ P/N 07501) or equivalent.
- Clean the hood using Varnish Makers and Painters (VMP) naphtha.
Installation Procedure
- Warm the hood with a heat
lamp or J 25070
to a minimum
of 21° C (70° F).
Peel the backing from the one end of the hood emblem.
Do not touch the adhesive backing.
- Press the hood emblem firmly to the body while continuing to remove
the backing.
- Inspect the hood emblem for adhesion.