Important: Do not overtighten the adjuster-to-floorpan nuts as a hard seat travel problem could result.

A small amount of fore and aft or side to side adjustment is available at the seat adjuster-to-floorpan attaching bolts which can be used toward alignment of the seat or alignment of the seat adjusters with each other. This adjustment is used to help correct the following conditions:

Operate the seat control switch until one adjuster reaches full-forward position. Detach the horizontal drive cable from the adjuster which has reached full-forward position. Operate the seat forward until other adjuster reaches full-forward position then connect horizontal drive cable and check horizontal travel of seat.

Operate the seat control switch until one adjuster has reached fully raised position at both front and rear vertical travel limits. Disconnect both vertical drive cables form adjuster which has reached the fully raised position. Operate the seat control switch until other adjuster reaches the fully raised position at both front and rear vertical limits. Connect previously removed front and rear vertical drive cables. Check vertical travel by operating adjusters through one or two complete cycles. The above operation may be repeated on an as-required basis if adjusters do not appear to be in phase after test cycle.